[docmagoo2]

hey I have a query?

Anyone know how to connect to a k700 with FARmanager? I have a DCU11 cable and a desktop stand both of which I have used for updating the firmware successfully. I understand that the desktop stand doesnt work with FAR but have been told the DCU11 does but I just cant seem to get it to connect to the phone. It says hold c etc etc but then the phone just powers on and doesnt go into flash mode? any ideas?

regards
doc

[Grawp]

It's very very simple:
you have to use service cable to connect k700i.
I've moded my DCU-11 to service cable, you just need to unconnect 5. pin from cable and connect unconnected 5. wire to 7. pin then unconnect 4.pin from cable and connect 4. wire to 6. pin and then finally connect 9 and 11 pin with wire;

sumarry:

move 5 to 7
move 4 to 6
connect 9 to 11

connector-when you face cable towards you and mobile-end-connector(opened) from you

1/3/5/7/9/11/ upper side
2/4/6/8/10/ bottom side

When you have cable connect USBs, start far, start sefp, set corect com, speed, cid, then reinsert baterry in your k700i, connect k700i, and ENTER THE MATRIX!!!

i think this information is helpful IMHO

This post has been edited by Grawp: 11 July 2006 - 01:04 PM