[Nick14]

Tools required: Torx 6 screwdriver

* Remove the battery, back cover and your memory card.


* Remove the two screws you see. Two screws are covered with rubber stoppers. Lift those out with something like a bic pen lid then remove these screws too.http://www.formymobile.co.uk/Dismantle/w89010.jpg
* You can now remove the front cover by running your fingernail all round the edge of the housing

* You'll now have the front cover removed, like below.

* Now lift the circuit board from left to right. The circuit board will still be attached by a ribbon so don't try and lift it away from the phone yet.

* The ribbon, indicated by the screwdriver in the picture below, attaches like a plug and socket. Simply lift it up to unplug it.

* Your phone should now look like below.

* Lift the green part shown below (it's held in place by a couple of clips around the edge) and you'll see three more ribbon connectors. Unplug the middle one

* Now turn the phone over and lever the old screen out

* You can now remove the LCD screen and replace with new. Reverse the whole procedure for reassembly.


Source: www.formymobile.co.uk

This post has been edited by Lynott: 27 April 2009 - 06:39 PM

[GizmoTheGreen]

Hi!

My sister dropped a w890 on the floor, from very low height (bed height) and it wont power on.

if i try to connect in bootmode (2+5) it kinda shows life, but then gives error.
holding C doesnt work at all.

any idea what could be wrong?

im not afraid of opening and soldering anything if you suspect a chips has come loose or similar, im confident in my soldering skills

thx