Second thing is to remove the housing around the microphone.
the easiest way is to use a knife.
Now u have something like this
modd_003.jpg 248.58K 865 downloads
Now take a knife and make a cut trough here.
be careful so u dont cut the wires.
then take out the small cord trough the hole.
modd1.JPG 45.26K 676 downloads
after u have done that, u will have something like this.
jongleringsboll_005.jpg 272.59K 594 downloads
then cut the cord right below the earpiece.
and make the longer cord evenly long with the shorter one.
modd2_002.jpg 219.13K 534 downloads
Now u can put together the mic housing, with a bit of pickin u can get the cord to go in between the parts.
then u need to carefully take out the green and blue wires from the rubber cover.
and then separate the green and the blue one.
sladd_003.jpg 221.82K 353 downloads
after that u solder the wires to the 3,5 mm plug.
jongleringsboll_010.jpg 62.98K 626 downloads
make sure that it is green/blue, blue/green
After that seal it up with tape or something else.
Enjoy! Hope it works out for u guys!
modd_av_sladd_009.jpg 236.01K 953 downloads
If u have any comments or tips about this please say.!
Edited by marran, 06 July 2006 - 05:15 PM.