[joe1203]

I have one V802SE and DSS-25

When I run SE Update Service, V802SE or Z800i are not shown in the supported mobile phone list. I suppose it is too old to be updated via SEUS

I have tried updating via XS++ 3.1, but failed.

I first remove the SIM card and Memory stick from the phone, insert a fully-charged battery and connect the phone to DSS-25 WITHOUT plugging the USB cable into the computer.

Then I run XS++, click connect, then plug the USB cable from DSS-25 to Computer USB port and hold the following keys.
1) holding the "c" button -> nothing happen in XS++, phone doesn't start
2) holding the "c" button and power button -> nothing happen in XS++,phone starts normally
3) holding the "<" button -> nothing happen in XS++,phone doesn't start
4) holding the "<" button and power button -> nothing happen in XS++,phone starts normally

I have checked the device list in device manager. I can find the "SEMC DSS-20 SyncStation" Driver installed at COM2 (Version 1.0.2115.0 2002-12-17)
I have also tried selecting "USB" port or "COM2" in XS++, but both doesn't work

Can anyone give me some hints? Did I do anything wrong?

[Norby]

Wotan? KulanKedi? TotalGSM? - could help you, but paid

SEtool? JDflasher? - could help you, free


SEtool and JD flasher should be tried also, and first!

[nothing_sweet]

Did you tried to hold button "2" ?

[joe1203]

Quote

Wotan? KulanKedi? TotalGSM? - could help you, but paid

SEtool? JDflasher? - could help you, free


SEtool and JD flasher should be tried also, and first!

The phone doesn't worth the paid service.
I will try SEtool or JDflasher later
Is SETools2Lite and SETool the same thing?

[joe1203]

Quote

Did you tried to hold button "2" ?

I have tried holding button 2 or Button 2+5, both doesn't work
The firmware used is R1J002/CID29