Okay so I saw Akshayys guide to this but I am having some problems. I have a w580i CID53 (I think) and I have the blinking red LED problem. So I got the SEToolLite and when I go "repair" it says "Cannot build loaders chain ".

Any ideas?

If its CID53 then SETool isn't compatable. Can you post the log please.

Here is the log from SEToolLite:

Welcome to SEtool2 ( LITE edition ) v 1.10
supported DB2010/DB2012 CID49/50/51/52, DB2020 CID49/51/52
Loaded 51 flash descriptors

if you like LITE edition - please visit www.setool.net and buy FULL.

ChipID:9900,EMP protocol:0301
PHONE IS RED RETAIL PRODUCT
FLASH CID detected:53
Speed:921600
OTP LOCKED:1 CID:51 PAF:1 IMEI:35224102838981 CERT:RED
FLASH CID:53 COLOR:RED
Can't build loaders chain ;(
Elapsed:42 secs.


A bit more detail into my situation:
I got this phone just over a year ago, and about 6 months ago I debranded it using WotanServer. Everything was fine until a couple weeks ago I was turning my phone off at the movies, and it never turned back on. I get the red flashing LED every time I try to turn it on. Battery is fully charged.

Thank you so much for all your help! I really need to get this phone going again! Thank you!

Try using JD flasher to falsh the main, fs and custom pack, and hope that sorts it after the battery has charged up (batteries tend to go flat after a while of not being used)

You could try cruiser's ultimate unlocker if nothing works.

Try reading this...
http://forums.se-nse.net/index.php?showtopic=28534&hl=
...might help, might not.