Hey, im not sure if this goes here on in the hardware section but heres my problem..

The connector on my w810.. where i connect headset/charger/cables all that.. is barely working.
if i wanna charge i have to put it in only a certain position for it to charge. and for the headset... I gave up on trying to use it because it disconnects at every step i make and barely recognizes any headset in the first place.

is there anywhere i can buy the piece + a tutorial on how to change it?
or if theres anythingi can do about it?

thanks!

note: the connector physically looks ok.. its kinda old and it shows but it hasnt had any physical damage to it except scratches from use

It is just a single piece with leads that slots into the PCB(Main Board) . It should be available in some phone parts shop and should not cost you more than 5 Pounds.

what site would i go to in order to buy such a piece ? and what would be the keywords im looking for?

w810i PCB ?

what i did find wwas these:
http://cnn.cn/shop/sonyericsson-w810i-keypad-p-1018.html
http://cnn.cn/shop/sonyericsson-w810i-flex-cable-p-757.html
http://cgi.ebay.ca/GENUINE-SONY-ERICSSON-W...p3286.m63.l1177

But none of these seem to have the plug connector jack.. which one would it be?

edit: also found this: http://cgi.ebay.ca/OEM-Board-Connector-11p...p3286.m20.l1116 .. seems a bit more like it.. x10 ..


edit2:
i think i found it!
http://www.mytrendyphone.com/shop/sony-eri...50i-10243p.html
can anybody confirm this is it.. and if i need anything else with that.. and where can i find a tutorial on how to install this

Help??

The last one is the one you need you need.

follow a guide

http://forums.se-nse.net/index.php?showtopic=27254

the connector slides of the board.

Take a Eraser and rub it against the connector of your phone( that was what DaDih* teached me)

I was waiting for instructions like the ones brookie gave ;D

I did try rubbing an eraser but it did noting better

HAHAHAHHAH FAAAIL!