CODE
>> 1 "When I tie my cel, it appears the message" error in the configuration, please contact the Service Provider. " >>
How to resolve this problem:
In this case, you must send the Custom Pack back to the cells, therefore, may have caused a mistake at the time of Transfers and resending only the cells return to normal.
To send the files:
Vamos precisar: We will need:
SETool2Lite SETool2Lite
Custom Packs
l Open SETool2Lite and choose the model of your cel.
l
l Now in "MISC FILES" add the CDA.
l
l Click "Flash".
l
l Remove and place the battery and connect the cel pressing "C".
l
l Wait for the completion of the procedure, so that the word "READY" appears
tudo esta pronto. everything is ready.
CODE
>> 2 "The SETool not recognize my cel, the status bar is running anything else happens."
You need to have installed the USB drivers, if you use the SETool is you also need the Flash Gordon's Gate Driver.
Install "Flash Gordon's Gate Driver."
You can find a flash drive on sites like "4shared.com", without more you know you already have the drivers, simply install them.
How to install:
Navigate to the folder where it installed the SETool.
Find the folder "drivers".
Inside the folder "drivers" folder is another name for:
"Usb_flash_driver."
Within that folder that the executable of Flash Gordon's Gate Driver.
CODE
>> 3 "My cel this in other language, how I change this?
His cel this or other language due to 2 possibilities:
1º You changed the language:
Menu> Conifgurações> General> Languages
2º Or your FS (FileSystem) is not correct for your country."
How to resolve:
This is a bit trickier because you need a pass to flash their cells.
Follow this tutorial as a base, after the files:
MAIN
FS
(Custom Pack)
CODE
>> Remembering that the files should be cited in accordance with their version of the CID and Firmware <<
CustPacks: http://files.sliderwithstyle.com/CustPacks/HB1-06/
DB2020 resources: http://forums.se-nse.net/index.php?showtopic=33634&st=0
Firmware files: http://forums.se-nse.net/index.php?showforum=88