well I m not sure that it`s the correct forum to add my topic bt I think as "setool2" is in this forum, my topic should also be here........
my phone is w610i! when i try to flash my phone using "bypass db2020 security" to apply "quick access patch", i get the following log........

CID52 BYPASS PROCEDURE STARTED
Processing part1...
CSloader version:
070410 1557 HANCXC1250562_DB2020_CSLOADER_R3A009
Processing part2...
Processing part3....
BOOTROM MODE DETECTED
OTP LOCKED:1 CID:51 PAF:1 IMEI:354********* CERT:N/A
FLASH CID:52 COLOR:RED
LDR:061201 1314 HANCXC1329129_DB2020_FLASHLOADER_R2A005
Flash ID check:2019
Flash props sent ok

REMOVE CABLE FROM PHONE
REMOVE BATTERY FROM PHONE, THEN INSERT IT BACK
THEN PRESS "READY"

HOLD "C" BUTTON AND ATTACH PHONE

CID52 BYPASS PROCEDURE FINISHED

ChipID:9900,EMP protocol:0301
PHONE IS RED RETAIL PRODUCT
FLASH CID detected:52
Speed:921600
Trying to launch embedded bootloader...
embedded flashloader not responds !
Elapsed:360 secs.


NOW some ppl may answer that its due to "bad cable" as I read some where before as well. But when I "only try to flash" my main, i get no error......!!!! then what can be the problem???? i can`t apply .vkp patches

Images (XS++ and jdflasher are also responding in a weird manner)

http://forums.se-nse.net/index.php?act=att...st&id=13847
http://forums.se-nse.net/index.php?act=att...st&id=13848

Are you just pressing the letter C or 2+5 because must be only letter C

Regards

thanx for the reply. I ONLY press C......... I really m BLANK on what to do next. As I told there`s no problem in "only flashing" with setool2lite. But XS++ doesn`t even "fully load" my phone at all and stucks here >>